AD9910SLASHPCBZ datasheet(59/60 Pages) AD

59 / 60 page

AD9910

Rev. 0 | Page 59 of 60

Profile Registers

There are eight consecutive serial I/O addresses (Address 0x0E

to Address 0x015) dedicated to device profiles. All eight profile

registers are either single tone profiles or RAM profiles. RAM

profiles are in effect when CFR1<31> = 1. Single tone profiles

are in effect when CFR1<31> = 0, CFR2<19> = 0, and CFR2<4>

= 0. In normal operation, the active profile register is selected

using the external PROFILE<2:0> pins. However, in the specific

case when CFR1<31> = 1 and CFR1<20:17> ≠ 00002, the active

profile is selected automatically (see the RAM Ramp Up

Internal Profile Control Mode section).

Profile 0 to Profile 7—Single Tone Register

Address 0x0E to Address 0x15, 8 bytes are assigned to this register.

Table 29. Bit Descriptions for Profile 0 to Profile 7 Single Tone Register

Bit(s)

Descriptor

Explanation

63:62

Not Available

61:48

Amplitude Scale Factor

This 14-bit number controls the DDS output amplitude.

47:32

Phase Offset Word

This 16-bit number controls the DDS phase offset.

31:0

Frequency Tuning Word

This 32-bit number controls the DDS frequency.

Profile 0 to Profile 7—RAM Register

Address 0x0E to Address 0x15, 8 bytes are assigned to this register.

Table 30. Bit Descriptions for Profile 0 to Profile 7 RAM Register

Bit(s)

Descriptor

Explanation

63:56

Not Available

55:40

Address Step Rate

16-bit address step rate value.

39:30

Waveform End Address

10-bit waveform end address.

29:24

Not Available

23:14

Waveform Start Address

10-bit waveform start address.

13:6

Not Available

No-Dwell High

Effective only when the RAM mode is in ramp up.

0 = when the RAM state machine reaches the end address, it halts.

1 = when the RAM state machines reaches the end address, it jumps to the start address

and halts.

Not Available

Zero-Crossing

Effective only when in RAM mode, direct switch.

0 = zero-crossing function disabled.

1 = zero-crossing function enabled.

2:0

RAM Mode Control

See Table 13 for details.

AD9910/PCBZ Datasheet(PDF) 59 Page - Analog Devices

AD9910/PCBZ Datasheet(HTML) 59 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datasheet Descarga

Enlace URL