ATtiny44 datasheet(121/236 Pages) ATMEL

121 / 236 page

121

8006H–AVR–10/09

ATtiny24/44/84

14.3.3

SPI Slave Operation Example

The following code demonstrates how to use the USI module as a SPI Slave:

init:

ldi

r16,(1<<USIWM0)|(1<<USICS1)

out

USICR,r16

...

SlaveSPITransfer:

out

USIDR,r16

ldi

r16,(1<<USIOIF)

out

USISR,r16

SlaveSPITransfer_loop:

r16, USISR

sbrs

r16, USIOIF

rjmp

SlaveSPITransfer_loop

r16,USIDR

ret

The code is size optimized using only eight instructions (plus return). The code example

assumes that the DO and USCK pins have been enabled as outputs in DDRA. The value stored

in register r16 prior to the function is called is transferred to the master device, and when the

transfer is completed the data received from the master is stored back into the register r16.

Note that the first two instructions are for initialization, only, and need only be executed once.

These instructions set three-wire mode and positive edge clock. The loop is repeated until the

USI Counter Overflow Flag is set.

14.3.4

Two-wire Mode

The USI two-wire mode is compliant to the Inter IC (TWI) bus protocol, but without slew rate lim-

iting on outputs and without input noise filtering. Pin names used in this mode are SCL and SDA.

Figure 14-4 shows two USI units operating in two-wire mode, one as master and one as slave. It

is only the physical layer that is shown since the system operation is highly dependent of the

communication scheme used. The main differences between the master and slave operation at

this level is the serial clock generation which is always done by the master. Only the slave uses

the clock control unit.

Clock generation must be implemented in software, but the shift operation is done automatically

in both devices. Note that clocking only on negative edges for shifting data is of practical use in

this mode. The slave can insert wait states at start or end of transfer by forcing the SCL clock

low. This means that the master must always check if the SCL line was actually released after it

has generated a positive edge.

Since the clock also increments the counter, a counter overflow can be used to indicate that the

transfer is completed. The clock is generated by the master by toggling the USCK pin via the

PORTA register.

ATtiny44 Datasheet(PDF) 121 Page - ATMEL Corporation

ATtiny44 Datasheet(HTML) 121 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL