ATtiny44 datasheet(86/236 Pages) ATMEL

86 / 236 page

8006H–AVR–10/09

ATtiny24/44/84

the flag. When the I-bit in SREG, OCIE0B (Timer/Counter Compare B Match Interrupt Enable),

and OCF0B are set, the Timer/Counter Compare Match Interrupt is executed.

• Bit 1– OCF0A: Output Compare Flag 0 A

The OCF0A bit is set when a Compare Match occurs between the Timer/Counter0 and the data

in OCR0A – Output Compare Register0. OCF0A is cleared by hardware when executing the cor-

responding interrupt handling vector. Alternatively, OCF0A is cleared by writing a logic one to

the flag. When the I-bit in SREG, OCIE0A (Timer/Counter0 Compare Match Interrupt Enable),

and OCF0A are set, the Timer/Counter0 Compare Match Interrupt is executed.

• Bit 0– TOV0: Timer/Counter0 Overflow Flag

The bit TOV0 is set when an overflow occurs in Timer/Counter0. TOV0 is cleared by hardware

when executing the corresponding interrupt handling vector. Alternatively, TOV0 is cleared by

writing a logic one to the flag. When the SREG I-bit, TOIE0 (Timer/Counter0 Overflow Interrupt

Enable), and TOV0 are set, the Timer/Counter0 Overflow interrupt is executed.

The setting of this flag is dependent of the WGM02:0 bit setting. See Table 11-8 on page 83 and

“Waveform Generation Mode Bit Description” on page 83.

ATtiny44 Datasheet(PDF) 86 Page - ATMEL Corporation