ATtiny44 datasheet(223/236 Pages) ATMEL

223 / 236 page

223

8006H–AVR–10/09

ATtiny24/44/84

26. Errata

The revision letters in this section refer to the revision of the corresponding ATtiny24/44/84

device.

26.1

ATtiny24

26.1.1

Rev. D – E

No known errata.

26.1.2

Rev. C

• Reading EEPROM when system clock frequency is below 900 kHz may not work

Reading EEPROM when system clock frequency is below 900 kHz may not work

Reading data from the EEPROM at system clock frequency below 900 kHz may result in

wrong data read.

Problem Fix/Work around

Avoid using the EEPROM at clock frequency below 900 kHz.

26.1.3

Rev. B

• EEPROM read from application code does not work in Lock Bit Mode 3

• Reading EEPROM when system clock frequency is below 900 kHz may not work

EEPROM read from application code does not work in Lock Bit Mode 3

When the Memory Lock Bits LB2 and LB1 are programmed to mode 3, EEPROM read does

not work from the application code.

Problem Fix/Work around

Do not set Lock Bit Protection Mode 3 when the application code needs to read from

EEPROM.

Reading EEPROM when system clock frequency is below 900 kHz may not work

Reading data from the EEPROM at system clock frequency below 900 kHz may result in

wrong data read.

Problem Fix/Work around

Avoid using the EEPROM at clock frequency below 900 kHz.

26.1.4

Rev. A

Not sampled.

ATtiny44 Datasheet(PDF) 223 Page - ATMEL Corporation