AD9911SLASHPCB datasheet(11/44 Pages) AD

11 / 44 page

AD9911

Rev. 0 | Page 11 of 44

Pin No.

Mnemonic

I/O

Description

6, 10, 12, 16, 28, 32

N/A

No Connection. Analog Devices recommends leaving these pins floating.

40, 41, 42, 43

P0, P1, P2, P3

These data pins are used for modulation (FSK, PSK, ASK), start/stop for the sweep

accumulator, and ramping up/down the output amplitude. Any toggle of these data

inputs is equivalent to an I/O_UPDATE. The data is synchronous to the SYNC_CLK (Pin

54). The data inputs must meet the set-up and hold time requirements to the

SYNC_CLK. This guarantees a fixed pipeline delay of data to the DAC output;

otherwise, a ±1 SYNC_CLK period of uncertainty occurs. The functionality of these

pins is controlled by profile pin configuration (PPC) bits in Register FR1 <12:14>.

I/O_UPDATE

A rising edge triggers data transfer from the I/O port buffer to active registers.

I/O_UPDATE is synchronous to the SYNC_CLK (Pin 54). I/O_UPDATE must meet the

set-up and hold time requirements to the SYNC_CLK to guarantee a fixed pipeline

delay of data to DAC output. If not, a ±1 SYNC_CLK period of uncertainty occurs. The

minimum pulse width is one SYNC_CLK period.

The active low chip select allows multiple devices to share a common I/O bus (SPI).

SCLK

Data Clock for I/O Operations. Data bits are written on the rising edge of SCLK and

read on the falling edge of SCLK.

DVDD_I/O

3.3 V Digital Power Supply for SPI Port and Digital I/O.

SDIO_0

I/O

Data pin SDIO_0 is dedicated to the I/O port only.

51, 52, 53

SDIO_1, SDIO_2,

SDIO_3

I/O

Data pins SDIO_1:3 can be used for the I/O port or to initiate a ramp up/ramp down

(RU/RD) of the DAC output amplitude.

SYNC_CLK

The SYNC_CLK, which runs at ¼ the system clock rate, can be disabled. I/O_UPDATE

and profile changes (Pin 40 to Pin 43) are synchronous to the SYNC_CLK. To guarantee

a fixed pipeline delay of data to DAC output, I/O_UPDATE and profile changes (Pin 40

to Pin 43) must meet the set-up and hold time requirements to the rising edge of

SYNC_CLK. If not, a ±1 SYNC_CLK period of uncertainty exists.

AD9911/PCB Datasheet(PDF) 11 Page - Analog Devices

AD9911/PCB Datasheet(HTML) 11 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Datasheet Descarga

Enlace URL