STM32G47PBY6TR datasheet(80/229 Pages) STMICROELECTRONICS

80 / 229 page

Electrical characteristics

STM32G473xB STM32G473xC STM32G473xE

80/229

DS12712 Rev 3

2. VIN maximum must always be respected. Refer to Table 15: Current characteristics for the maximum

allowed injected current values.

3. This formula has to be applied only on the power supplies related to the IO structure described in the pin

definition table.

4. To sustain a voltage higher than 4 V the internal pull-up/pull-down resistors must be disabled.

5. Include VREF- pin.

Table 15. Current characteristics

Symbol

Ratings

Max

Unit

∑IVDD

Total current into sum of all VDD power lines (source)(1)

1. All main power (VDD, VDDA, VBAT) and ground (VSS, VSSA) pins must always be connected to the external

power supplies, in the permitted range.

150

∑IVSS

Total current out of sum of all VSS ground lines (sink)(1)

150

IVDD(PIN)

Maximum current into each VDD power pin (source)(1)

100

IVSS(PIN)

Maximum current out of each VSS ground pin (sink)(1)

100

IIO(PIN)

Output current sunk by any I/O and control pin except FT_f

Output current sunk by any FT_f pin

Output current sourced by any I/O and control pin

∑IIO(PIN)

Total output current sunk by sum of all I/Os and control pins(2)

2. This current consumption must be correctly distributed over all I/Os and control pins. The total output

current must not be sunk/sourced between two consecutive power supply pins referring to high pin count

LQFP packages.

100

Total output current sourced by sum of all I/Os and control pins(2)

100

IINJ(PIN)(3)

3. Positive injection (when VIN > VDD) is not possible on these I/Os and does not occur for input voltages

lower than the specified maximum value.

Injected current on FT_xxx, TT_xx, NRST pins

-5/0(4)

4. A negative injection is induced by VIN < VSS. IINJ(PIN) must never be exceeded. Refer also to Table 14:

Voltage characteristics for the minimum allowed input voltage values.

∑|IINJ(PIN)| Total injected current (sum of all I/Os and control pins)(5)

5. When several inputs are submitted to a current injection, the maximum ∑|IINJ(PIN)| is the absolute sum of

the negative injected currents (instantaneous values).

±25

Table 16. Thermal characteristics

Symbol

Ratings

Value

Unit

TSTG

Storage temperature range

–65 to +150

°C

Maximum junction temperature

150

°C

STM32G47PBY6TR Datasheet(PDF) 80 Page - STMicroelectronics

STM32G47PBY6TR Datasheet(HTML) 80 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL