STM32G47PBY6TR datasheet(46/229 Pages) STMICROELECTRONICS

No. de pieza	STM32G47PBY6TR

Descripción Electrónicos	Arm® Cortex®-M4 32-bit MCUFPU, up to 512 KB Flash, 170 MHz / 213DMIPS, 128 KB SRAM, rich analog, math accelerator

PDF	229 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

46 / 229 page

Functional overview

STM32G473xB STM32G473xC STM32G473xE

46/229

DS12712 Rev 3

3.39

Development support

3.39.1

Serial wire JTAG debug port (SWJ-DP)

The Arm SWJ-DP interface is embedded, and is a combined JTAG and serial wire debug

port that enables either a serial wire debug or a JTAG probe to be connected to the target.

Debug is performed using 2 pins only instead of 5 required by the JTAG (JTAG pins could

be re-use as GPIO with alternate function): the JTAG TMS and TCK pins are shared with

SWDIO and SWCLK, respectively, and a specific sequence on the TMS pin is used to

switch between JTAG-DP and SW-DP.

3.39.2

Embedded trace macrocell™

The Arm embedded trace macrocell provides a greater visibility of the instruction and data

flow inside the CPU core by streaming compressed data at a very high rate from the

STM32G473xB/xC/xE devices through a small number of ETM pins to an external hardware

trace port analyzer (TPA) device. Real-time instruction and data flow activity be recorded

and then formatted for display on the host computer that runs the debugger software. TPA

hardware is commercially available from common development tool vendors.

The Embedded trace macrocell operates with third party debugger software tools.

STM32G47PBY6TR Datasheet(PDF) 46 Page - STMicroelectronics