ST72325AR9-Auto datasheet(45/243 Pages) STMICROELECTRONICS

45 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

ST72325xxx-Auto

Supply, reset and clock management

Doc ID 13770 Rev 3

45/243

The basic RESET sequence consists of three phases as shown in Figure 13:

●

Active phase depending on the RESET source

●

256 or 4096 CPU clock cycle delay (selected by option byte)

●

RESET vector fetch

Caution:

When the ST7 is unprogrammed or fully erased, the Flash is blank and the RESET vector is

not programmed. For this reason, it is recommended to keep the RESET pin in low state

until programming mode is entered, in order to avoid unwanted behavior.

The 256 or 4096 CPU clock cycle delay allows the oscillator to stabilize and ensures that

recovery has taken place from the Reset state. The shorter or longer clock cycle delay

should be selected by option byte to correspond to the stabilization time of the external

oscillator used in the application (see Section 21.1.1: Flash configuration).

The RESET vector fetch phase duration is 2 clock cycles.

Figure 12.

Reset block diagram

Figure 13.

RESET sequence phases

6.5.2

Asynchronous external RESET pin

The RESET pin is both an input and an open-drain output with integrated RON weak pull-up

resistor. This pull-up has no fixed value but varies in accordance with the input voltage. It

can be pulled low by external circuitry to reset the device. See Section 19.9: Control pin

characteristicsfor more details.

A RESET signal originating from an external source must have a duration of at least

th(RSTL)in in order to be recognized (see Figure 14). This detection is asynchronous and

therefore the MCU can enter reset state even in Halt mode.

RESET

RON

VDD

WATCHDOG RESET

LVD RESET

INTERNAL

RESET

PULSE

GENERATOR

Filter

RESET

ACTIVE PHASE

INTERNAL RESET

256 or 4096 CLOCK CYCLES

FETCH

VECTOR

ST72325AR9-Auto Datasheet(PDF) 45 Page - STMicroelectronics

ST72325AR9-Auto Datasheet(HTML) 45 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL