ST72325AR9-Auto datasheet(81/243 Pages) STMICROELECTRONICS

81 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

ST72325xxx-Auto

Watchdog timer (WDG)

Doc ID 13770 Rev 3

81/243

Watchdog timer (WDG)

10.1

Introduction

The Watchdog timer is used to detect the occurrence of a software fault, usually generated

by external interference or by unforeseen logical conditions, which causes the application

program to abandon its normal sequence. The Watchdog circuit generates an MCU reset on

expiry of a programmed time period, unless the program refreshes the counter’s contents

before the T6 bit becomes cleared.

10.2

Main features

●

Programmable free-running downcounter

●

Programmable reset

●

Reset (if watchdog activated) when the T6 bit reaches zero

●

Optional reset on HALT instruction (configurable by option byte)

●

Hardware Watchdog selectable by option byte

10.3

Functional description

The counter value stored in the Watchdog Control register (WDGCR bits T[6:0]), is

decremented every 16384 fOSC2 cycles (approx.), and the length of the timeout period can

be programmed by the user in 64 increments.

If the watchdog is activated (the WDGA bit is set) and when the 7-bit timer (bits T[6:0]) rolls

over from 40h to 3Fh (T6 becomes cleared), it initiates a reset cycle pulling the RESET pin

low for typically 30µs.

The application program must write in the WDGCR register at regular intervals during

normal operation to prevent an MCU reset. This downcounter is free-running: It counts down

even if the watchdog is disabled. The value to be stored in the WDGCR register must be

between FFh and C0h:

–

The WDGA bit is set (watchdog enabled)

–

The T6 bit is set to prevent generating an immediate reset

–

The T[5:0] bits contain the number of increments which represents the time delay

before the watchdog produces a reset (see Figure 34: Approximate timeout

duration). The timing varies between a minimum and a maximum value due to the

unknown status of the prescaler when writing to the WDGCR register (see

Figure 35).

Following a reset, the watchdog is disabled. Once activated it cannot be disabled, except by

a reset.

The T6 bit can be used to generate a software reset (the WDGA bit is set and the T6 bit is

cleared).

If the watchdog is activated, the HALT instruction will generate a Reset.

ST72325AR9-Auto Datasheet(PDF) 81 Page - STMicroelectronics

ST72325AR9-Auto Datasheet(HTML) 81 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL