RMLD232UAW datasheet(6/50 Pages) EMLSI

6 / 50 page

Rev 0.7

64Mb Low Power DDR SDRAM

Advanced

Mode Register Definition

Mode Register Set (MRS)

The mode register is designed to support the various operating modes of DDR SDRAM. It includes CAS latency, addressing mode,

burst length, test mode and vendor specific options to make DDR SDRAM useful for variety of applications. The default value of the

mode register is not defined, therefore the mode register must be written in the power up sequence of DDR SDRAM. The mode reg-

ister is written by asserting low on CS, RAS, CAS and WE(The DDR SDRAM should be in active mode with CKE already high prior to

writing into the mode register). The state of address pins A0~A10 and BA0, BA1 in the same cycle as CS, RAS, CAS and WE going

low is written in the mode register. Two clock cycles are required to complete the write operation in the mode register. Even if the

power-up sequence is finished and some read or write operations is executed afterward, the mode register contents can be changed

with the same command and four clock cycles. This command must be issued only when all banks are in the idle state. If mode reg-

ister is changed, extended mode register automatically is reset and come into default state. So extended mode register must be set

again. The mode register is divided into various fields depending on funtionality. The burst length uses A0 ~ A2, addressing mode

uses A3, CAS latency(read latency from column address) uses A4 ~ A6. A7 ~ A10 are used for test mode. BA0 and BA1 must be set

to low for normal DDR SDRAM operation.

BA1

BA0

A10

CAS Latency

Burst Length

CAS Latency

Reserve

Burst Type

Sequential

Interleave

Burst Length

Burst Type

Sequential

Interleave

Reserve

Figure.2 Mode Register Set

Address Bus

Mode Register

RMLD232UAW Datasheet(PDF) 6 Page - Emerging Memory & Logic Solutions Inc