| Motor de Búsqueda de Datasheet de Componentes Electrónicos |
|
WM9093ECS/R Datasheet(PDF) 57 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM9093ECS/R Datasheet(HTML) 57 Page - Wolfson Microelectronics plc |
|
57 / 84 page ![]() Production Data WM9093 w PD, March 2012, Rev 4.2 57 THERMAL SHUTDOWN The WM9093 incorporates a temperature sensor which detects when the device temperature is within normal limits or if the device is approaching a hazardous temperature condition. The temperature status can be polled at any time by reading the TSHUT register bit. The temperature sensor can be configured to automatically disable the audio outputs of the WM9093 in response to an over-temperature condition (approximately 150ºC). The temperature sensor is enabled by setting the TSHUT_ENA register bit. When the TSHUT_OPDIS is also set, then a device over-temperature condition will cause the speaker output (OUT+ and OUT-) to be disabled; this response is likely to prevent any damage to the device attributable to the large currents of the speaker output driver. When the temperature sensor is enabled, the temperature status can be read from the TSHUT register bit. Note that, to prevent pops and clicks, TSHUT_ENA and TSHUT_OPDIS should only be updated whilst the speaker and headphone outputs are disabled. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION R2 (02h) Power Management (2) 15 TSHUT (read only) 0 Thermal shutdown status 0 = Normal temperature 1 = Over temperature 14 TSHUT_ENA 1 Thermal sensor enable 0 = Disabled 1 = Enabled 13 TSHUT_OPDIS 1 Thermal shutdown control (Causes audio outputs to be disabled if an overtemperature occurs. The thermal sensor must also be enabled.) 0 = Disabled 1 = Enabled Table 33 Thermal Shutdown SOFTWARE RESET AND CHIP ID A Software Reset can be commanded by writing to Register R0. This is a read-only register field and the contents will not be affected by writing to this Register. The Chip ID can be read back from Register R0. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION R0 (00h) Software Reset 15:0 SW_RESET [15:0] 9093h Writing to this register causes a Software Reset. Reading from this register will indicate Chip ID. Table 34 Chip Reset and ID |
|
Enlace URL |
| ¿ALLDATASHEET es útil para Ud.? [ DONATE ] |
Todo acerca de Alldatasheet | Publicidad | Contáctenos | Política de Privacidad | Enlace a la hoja de datos | Intercambio de Enlaces | Lista de Fabricantes All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |