WM9093ECSSLASHR datasheet(54/84 Pages) WOLFSON

54 / 84 page

WM9093

Production Data

PD, March 2012, Rev 4.2

REFERENCE VOLTAGES AND MASTER BIAS

This section describes the analogue reference voltage and bias current controls. It also describes the

VMID soft-start circuit for pop suppressed start-up and shut-down.

The analogue circuits in the WM9093 require a mid-rail analogue reference voltage, VMID. This

reference is generated from HPVDD via a programmable resistor chain. Together with the external

decoupling capacitor (connected to the BIAS pin), the programmable resistor chain results in a slow,

normal or fast charging characteristic on VMID.

VMID is enabled by setting the VMID_ENA register bit. The programmable resistor chain is

configured by VMID_RES[1:0], and can be used to optimise the reference for normal operation, low

power standby or for fast start-up as described in Table 31.

When VMID is enabled using VMID_ENA, the WM9093 automatically controls VMID using a pop-

suppression circuit to avoid a step change in VMID; this suppresses pop/click noise which could

otherwise occur.

By default, the 2 x 5k

 VMID divider is selected in order to allow fast start-up. For normal operation

and lower power consumption, the VMID_RES register should be updated after start-up to select

another resistor value.

The analogue circuits in the WM9093 require a bias current. The normal bias current is enabled by

setting BIAS_ENA. Note that the normal bias current source requires VMID to be enabled also.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R1 (01h)

Power

Management

(1)

2:1

VMID_RES

[1:0]

VMID Divider Enable and Select

00 = VMID disabled (for OFF mode)

01 = 2 x 50k

 divider (for normal operation)

10 = 2 x 250k

 divider (for low power standby)

11 = 2 x 5k

 divider (for fast start-up)

BIAS_ENA

Enables the Normal bias current generator (for

all analogue functions)

0 = Disabled

1 = Enabled

R57 (39h)

AntiPOP2

VMID_ENA

Enable VMID master bias current source

0 = Disabled

1 = Enabled

Table 31 Reference Voltages and Master Bias Enable

WM9093ECS/R Datasheet(PDF) 54 Page - Wolfson Microelectronics plc

WM9093ECS/R Datasheet(HTML) 54 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

Datasheet Descarga

Enlace URL