M25P05-AVMP6TP datasheet(14/52 Pages) NUMONYX

14 / 52 page

Operating features

M25P05-A

14/52

4.6

Protection modes

The environments where non-volatile memory devices are used can be very noisy. No SPI

device can operate correctly in the presence of excessive noise. To help combat this, the

M25P05-A features the following data protection mechanisms:

●

Power on reset and an internal timer (tPUW) can provide protection against inadvertent

changes while the power supply is outside the operating specification

●

Program, erase and write status register instructions are checked that they consist of a

number of clock pulses that is a multiple of eight, before they are accepted for

execution

●

All instructions that modify data must be preceded by a write enable (WREN)

instruction to set the write enable latch (WEL) bit. This bit is returned to its reset state

by the following events:

–Power-up

–

Write disable (WRDI) instruction completion

–

Write status register (WRSR) instruction completion

–

Page program (PP) instruction completion

–

Sector erase (SE) instruction completion

–

Bulk erase (BE) instruction completion

●

The block protect (BP1, BP0) bits allow part of the memory to be configured as read-

only. This is the software protected mode (SPM)

●

The Write Protect (W) signal, in co-operation with the status register write disable

(SRWD) bit, allows the block protect (BP1, BP0) bits and status register write disable

(SRWD) bit to be write-protected. This is the hardware protected mode (HPM)

●

In addition to the low power consumption feature, the deep power-down mode offers

extra software protection, as all write, program and erase instructions are ignored.

The device is ready to accept a bulk erase instruction if, and only if, both block protect (BP1, BP0) are 0.

Table 2.

Protected area sizes

Status Register

content

Memory content

BP1 bit

BP0 bit

Protected area

Unprotected area

none

All sectors (sectors 0 and 1)

No protection against page program (PP) and sector erase (SE)

All sectors (sectors 0 and 1) protected against bulk erase (BE)

All sectors (sectors 0 and 1)

none

M25P05-AVMP6TP Datasheet(PDF) 14 Page - Numonyx B.V

M25P05-AVMP6TP Datasheet(HTML) 14 Page - Numonyx B.V

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Descarga

Enlace URL