TUSB8043RGCT datasheet(3/59 Pages) TI1

3 / 59 page

TUSB8043

www.ti.com

SLLSEW4 – JUNE 2017

Product Folder Links: TUSB8043

Submit Documentation Feedback

5 Description (Continued)

When the upstream port is connected to an electrical environment that only supports full-speed/low-speed

connections, SuperSpeed USB and high-speed connectivity are disabled on the downstream ports.

The TUSB8043 supports per port or ganged power switching and over-current protection, and supports battery

charging applications.

An individually port power controlled hub switches power on or off to each downstream port as requested by the

USB host. Also when an individually port power controlled hub senses an over-current event, only power to the

affected downstream port will be switched off.

A ganged hub switches on power to all its downstream ports when power is required to be on for any port. The

power to the downstream ports is not switched off unless all ports are in a state that allows power to be removed.

Also when a ganged hub senses an over-current event, power to all downstream ports will be switched off.

The TUSB8043 downstream ports provide support for battery charging applications by providing Battery

Charging Downstream Port (CDP) handshaking support. It also supports a Dedicated Charging Port (DCP) mode

when the upstream port is not connected. The DCP mode supports USB devices which support with the USB

Battery Charging, Galaxy Charging, and Chinese Telecommunications Industry Standard YD/T 1591-2009. In

addition when upstream port is unconnected, the TUSB8043 supports the divider charging port modes (ACPx

modes) and an automatic transition through all modes, starting with ACP3 and ending in DCP.

The TUSB8043 provides pin strap configuration for some features including battery charging support, and also

provides customization though OTP ROM, I2C EEPROM, or via an I2C/SMBus slave interface for PID, VID, and

custom port and phy configurations. Custom string support is also available when using an I2C EEPROM or the

I2C/SMBus slave interface.

The TUSB8043 supports programming of an attached EEPROM through its internal USB HID to I2C interface.

The device is available in a 64-pin RGC package and is offered in a commercial version for operation over the

temperature range of 0°C to 70°C.

TUSB8043RGCT Datasheet(PDF) 3 Page - Texas Instruments