MEC1322 datasheet(89/456 Pages) MICROCHIP

89 / 456 page

 2014 - 2015 Microchip Technology Inc.

DS00001719D-page 89

MEC1322

Note 5-8

The Begin Address indicates where the first register can be accessed in a particular address space

for a block instance.

5.9.1

LPC ACTIVATE REGISTER

The LPC Activate Register controls the LPC device itself. The Host can shut down the LPC Logical Device by clearing

the Activate bit, but it cannot restart the LPC interface, since once the LPC interface is inactive the Host has no access

to any registers on the device. The Embedded Controller can set or clear the Activate bit at any time.

APPLICATION NOTE:

The bit in the LPC Activate Register should not be written ‘0’ to by the Host over LPC.

5.9.2

SERIAL IRQ CONFIGURATION REGISTERS

The LPC Controller implements 16 IRQ channels that may be configured to be asserted by any logical device.

• For a description of the SIRQ Configuration Register format see Table 5-15, “SIRQ Interrupt Configuration Regis-

ter Map,” on page 90.

• For a summary of the SIRQ IRQ Configuration registers implemented see Table 5-16, “I/O Base Address Regis-

ters,” on page 92.

• For a list of the SIRQ sources see Table 5-12, “Logical Device Sirq Routing,” on page 87.

TABLE 5-13:

CONFIGURATION REGISTER ADDRESS RANGE TABLE

Instance NAME

Instance

Number

Host

Address Space

Begin Address

(

Note 5-8

LPC Interface

LPC

Configuration Port

INDEX = 00h

32-bit internal

address space

400F_3300h

TABLE 5-14:

CONFIGURATION REGISTER SUMMARY

Offset

Size

Notes

LPC Activate Register

30h

SIRQ Configuration Register Format

40h - 4Fh

I/O Base Address Registers (BARs)

See Table 5-16

Device Memory Base Address Registers

See Table 5-17

Offset

30h

Bits

Description

Type

Default

Reset

Event

7:1 RESERVED

RES

0 ACTIVATE

1= Activate

When this bit is 1, the LPC Logical Device is powered and functional.

0= Deactivate

When this bit is 0, the logical device is powered down and inactive.

Except for the LPC Activate Register itself, clocks to the block are

gated and the LPC Logical Device will permit the ring oscillator to be

shut down (see Section 5.11.4, "EC Clock Control Register," on

page 96). LPC bus output pads will be tri-stated.

R/W

VCC1_R

ESET

MEC1322 Datasheet(PDF) 89 Page - Microchip Technology

MEC1322 Datasheet(HTML) 89 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL