T89C51CC02CA-RATIM datasheet(117/145 Pages) ATMEL

117 / 145 page

117

T89C51CC02

4126D–CAN–05/03

The bits SCH0 to SCH2 in ADCON register are used for the analog input channel

selection.

Table 96. Selected Analog input

Voltage Conversion

When the ADCIN is equals to VAREF the ADC converts the signal to 3FFh (full scale). If

the input voltage equals VAGND, the ADC converts it to 000h. Input voltage between

VAREF and VAGND are a straight-line linear conversion. All other voltages will result in

3FFh if greater than VAREF and 000h if less than VAGND.

Note that ADCIN should not exceed VAREF absolute maximum range (See section

“AC-DC”).

Clock Selection

The ADC clock is the same as CPU.

The maximum clock frequency for ADC is 700 kHz. A prescaler is featured (ADCCLK) to

generate the ADC clock from the oscillator frequency.

Figure 50. A/D Converter Clock

ADC Standby Mode

When the ADC is not used, it is possible to set it in standby mode by clearing bit ADEN

in ADCON register. In this mode the power dissipation is reduced.

IT ADC management

An interrupt end-of-conversion will occurs when the bit ADEOC is activated and the bit

EADC is set. For re-arming the interrupt the bit ADEOC must be cleared by software.

SCH2

SCH1

SCH0

Selected Analog Input

AN0

AN1

AN2

AN3

AN4

AN5

AN6

AN7

Prescaler ADCLK

A/D

Converter

ADC Clock

CPU

CLOCK

CPU Core Clock Symbol

÷ 2

T89C51CC02CA-RATIM Datasheet(PDF) 117 Page - ATMEL Corporation

T89C51CC02CA-RATIM Datasheet(HTML) 117 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL