M25P05-AVMP6T datasheet(21/34 Pages) STMICROELECTRONICS

No. de pieza	M25P05-AVMP6T

Descripción Electrónicos	512 Kbit, Low Voltage, Serial Flash Memory With 25 MHz SPI Bus Interface

PDF	34 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

21 / 34 page

21/34

M25P05-A

Figure 19. Release from Deep Power-down (RES) Instruction Sequence

Driving Chip Select (S) High after the 8-bit instruc-

tion byte has been received by the device, but be-

fore the whole of the 8-bit Electronic Signature has

been transmitted for the first time (as shown in Fig-

ure 19), still insures that the device is put into

Stand-by Power mode. If the device was not pre-

viously in the Deep Power-down mode, the transi-

tion to the Stand-by Power mode is immediate. If

the device was previously in the Deep Power-

down mode, though, the transition to the Stand-by

Power mode is delayed by tRES1, and Chip Select

(S) must remain High for at least tRES1(max), as

specified in Table 13. Once in the Stand-by Power

mode, the device waits to be selected, so that it

can receive, decode and execute instructions.

AI04078B

34567

tRES1

Stand-by Mode

Deep Power-down Mode

High Impedance

Instruction

M25P05-AVMP6T Datasheet(PDF) 21 Page - STMicroelectronics