M25P05-AVMP6T datasheet(15/34 Pages) STMICROELECTRONICS

15 / 34 page

15/34

M25P05-A

Figure 13. Read Data Bytes at Higher Speed (FAST_READ) Instruction Sequence and Data-Out

Sequence

Note: 1. Address bits A23 to A16 must be set to 00h.

Read Data Bytes at Higher Speed

(FAST_READ)

The device is first selected by driving Chip Select

(S) Low. The instruction code for the Read Data

Bytes at Higher Speed (FAST_READ) instruction

is followed by a 3-byte address (A23-A0) and a

dummy byte, each bit being latched-in during the

rising edge of Serial Clock (C). Then the memory

contents, at that address, is shifted out on Serial

Data Output (Q), each bit being shifted out, at a

maximum frequency fC, during the falling edge of

Serial Clock (C).

The instruction sequence is shown in Figure 13.

The first byte addressed can be at any location.

The address is automatically incremented to the

next higher address after each byte of data is shift-

ed out. The whole memory can, therefore, be read

with a single Read Data Bytes at Higher Speed

(FAST_READ) instruction.

There is no address roll-over; when the highest

address (0FFFFh) is reached, the instruction

should be terminated.

The

Read

Data

Bytes

Higher

Speed

(FAST_READ) instruction is terminated by driving

Chip Select (S) High. Chip Select (S) can be driv-

en High at any time during data output. Any Read

Data Bytes at Higher Speed (FAST_READ) in-

struction, while an Erase, Program or Write cycle

is in progress, is rejected without having any ef-

fects on the cycle that is in progress.

AI04006

3456789 10

28 29 30 31

22 21

3210

High Impedance

Instruction

24 BIT ADDRESS

32 33 34

36 37 38 39 40 41 42 43 44 45 46

765432

DATA OUT 1

Dummy Byte

MSB

6543210

DATA OUT 2

MSB

765432

M25P05-AVMP6T Datasheet(PDF) 15 Page - STMicroelectronics

M25P05-AVMP6T Datasheet(HTML) 15 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Datasheet Descarga

Enlace URL