DSPIC33F datasheet(34/80 Pages) MICROCHIP

34 / 80 page

dsPIC33F/PIC24H PROGRAMMING SPECIFICATION

DS70152D-page 34

Preliminary

3.2

Confirming the Presence of the

Programming Executive

Before programming can begin, the programmer must

confirm that the programming executive is stored in

executive memory. The procedure for this task is

shown in Figure 3-2.

First, ICSP mode is entered. Then, the unique Applica-

tion ID Word stored in executive memory is read. If the

programming executive is resident, the Application ID

Word is 0xBB, which means programming can resume

as normal. However, if the Application ID Word is not

0xBB, the programming executive must be programmed

to executive code memory using the method described in

Section 6.0 “Programming the Programming Exec-

utive to Memory”.

Section 5.0 “Device Programming – ICSP” describes

the ICSP programming method. Section 5.11 “Reading

the Application ID Word” describes the procedure for

reading the Application ID Word in ICSP mode.

FIGURE 3-2:

CONFIRMING PRESENCE

OF PROGRAMMING

EXECUTIVE

3.3

Entering Enhanced ICSP Mode

As shown in Figure 3-3, entering Enhanced ICSP

Program/Verify mode requires three steps:

The MCLR pin is briefly driven high then low.

A 32-bit key sequence is clocked into PGD.

MCLR is then driven high within a specified

period of time and held.

The programming voltage applied to MCLR is VIH,

which is essentially VDD in the case of dsPIC33F/

PIC24H devices. There is no minimum time require-

ment for holding at VIH. After VIH is removed, an inter-

val of at least P18 must elapse before presenting the

key sequence on PGD.

The key sequence is a specific 32-bit pattern,

‘0100 1101 0100 0011 0100 1000 0101 0000’

(more easily remembered as 0x4D434850 in hexa-

decimal format). The device will enter Program/Verify

mode only if the key sequence is valid. The Most

Significant bit (MSb) of the most significant nibble must

be shifted in first.

Once the key sequence is complete, VIH must be

applied to MCLR and held at that level for as long as

Program/Verify mode is to be maintained. An interval

time of at least P19 and P7 must elapse before present-

ing data on PGD. Signals appearing on PGD before P7

has elapsed will not be interpreted as valid.

On successful entry, the program memory can be

accessed and programmed in serial fashion. While in

the Program/Verify mode, all unused I/Os are placed in

the high-impedance state.

Start

Enter ICSP™ Mode

Application ID

0xBB?

Resident in Memory

Yes

Prog. Executive is

Application ID

Read the

be Programmed

Prog. Executive must

from Address

0x807F0

Finish

DSPIC33F Datasheet(PDF) 34 Page - Microchip Technology

DSPIC33F Datasheet(HTML) 34 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

Datasheet Descarga

Enlace URL