AD8065ART-R2 datasheet(20/28 Pages) AD

20 / 28 page

AD8065/AD8066

Rev. E | Page 20 of 28

THERMAL CONSIDERATIONS

With 24 V power supplies and 6.5 mA quiescent current, the

AD8065 dissipates 156 mW with no load. The AD8066

dissipates 312 mW. This can lead to noticeable thermal effects,

especially in the small SOT-23-5 (thermal resistance of

160°C/W). VOS temperature drift is trimmed to guarantee a

maximum drift of 17 µV/°C, so it can change up to 0.425 mV

due to warm-up effects for an AD8065/AD8066 in a SOT-23-5

package on 24 V.

Ib increases by a factor of 1.7 for every 10°C rise in temperature.

Ib will be close to 5 times higher at 24 V supplies as opposed to a

single 5 V supply.

Heavy loads will increase power dissipation and raise the chip

junction temperature as described in the Maximum Power

Dissipation section. Care should be taken to not exceed the

rated power dissipation of the package.

INPUT AND OUTPUT OVERLOAD BEHAVIOR

The AD8065/AD8066 have internal circuitry to guard against

phase reversal due to overdriving the input stage. A simplified

schematic of the input stage, including the input-protection

diodes and antiphase reversal circuitry, is shown in Figure 56.

The circuit is arranged such that when the input common-

mode voltage exceeds a certain threshold, the input JFET pair’s

bias current will turn OFF, and the bias current of an auxiliary

NPN pair will turn ON, taking over control of the amplifier.

When the input common-mode voltage returns to a viable

operating value, the FET stage turns back ON, the NPN stage

turns OFF, and normal operation resumes.

The NPN pair can sustain operation with the input voltage up

to the positive supply, so this is a pseudo rail-to-rail input stage.

For operation beyond the FET stage’s common-mode limit, the

amplifier’s VOS will change to the NPN pair’s offset (mean of

160 µV, standard deviation of 820 µV), and Ib will increase to the

NPN pair’s base current up to 45 µA (see Figure 32).

Switchback, or recovery time, is about 100 ns, see Figure 27.

The output transistors of the rail-to-rail output stage have

circuitry to limit the extent of their saturation when the output

is overdriven. This helps output recovery time. Output recovery

from a 0.5 V output overdrive on a ±5 V supply is shown in

Figure 24.

AD8065ART-R2 Datasheet(PDF) 20 Page - Analog Devices

AD8065ART-R2 Datasheet(HTML) 20 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Descarga

Enlace URL