UM1008 datasheet(5/32 Pages) STMICROELECTRONICS

No. de pieza	UM1008

Descripción Electrónicos	Demonstration kit for the ST7570 power line modem

PDF	32 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

5 / 32 page

UM1008

Connection procedure

Doc ID 18032 Rev 2

5/32

Connection procedure

In order to connect EVALKITST7570-1 to the PC, the user must follow the instructions

below:

Connect the board to the PC using a USB cable.

Plug a power cable into the board AC power plug.

Plug the power cable into the power socket.

As soon as the board is powered, the power LEDs switch on.

USB/UART adapter driver installation

The USB communication between the EVALKITST7570-1 and the PC is managed through

an onboard USB to UART adapter. This device needs the installation of the correct device

software driver on the PC.

Assuming that the device drivers are not yet installed, follow the instructions below:

Download the latest available Virtual COM Port (VCP) drivers from the FTDI web site

(www.ftdichip.com) and unzip them to a location on the host PC.

Connect the EVALKITST7570-1 to a spare USB port on the host PC. The screen

shown in Figure 2 is displayed. Select “No, not this time” from the options available and

then click “Next” to proceed with the installation.

Figure 2.

Hardware update wizard screen

UM1008 Datasheet(PDF) 5 Page - STMicroelectronics