AT25DF081A datasheet(40/54 Pages) ETC2

40 / 54 page

8715C–SFLSH–1/2013

AT25DF081A

Figure 12-3. Deep Power-Down

12.4 Resume from Deep Power-Down

In order to exit the Deep Power-Down mode and resume normal device operation, the Resume from Deep Power-

Down command must be issued. The Resume from Deep Power-Down command is the only command that the

device will recognized while in the Deep Power-Down mode.

To resume from the Deep Power-Down mode, the CS pin must first be asserted and opcode of ABh must be

clocked into the device. Any additional data clocked into the device after the opcode will be ignored. When the CS

pin is deasserted, the device will exit the Deep Power-Down mode within the maximum time of tRDPD and return to

the standby mode. After the device has returned to the standby mode, normal command operations such as Read

Array can be resumed.

If the complete opcode is not clocked in before the CS pin is deasserted, or if the CS pin is not deasserted on an

even byte boundary (multiples of eight bits), then the device will abort the operation and return to the Deep Power-

Down mode.

Figure 12-4. Resume from Deep Power-Down

SCK

MSB

ICC

10111001

OPCODE

HIGH-IMPEDANCE

Standby Mode Current

Active Current

Deep Power-Down Mode Current

tEDPD

SCK

MSB

ICC

10101011

OPCODE

HIGH-IMPEDANCE

Deep Power-Down Mode Current

Active Current

Standby Mode Current

tRDPD

AT25DF081A Datasheet(PDF) 40 Page - List of Unclassifed Manufacturers