RX610

Renesas Starter Kit Sample Code for CubeSuite+

R20AN0274EJ0100 Rev. 1.00

Page 4 of 6

Jan. 17, 2014

6.

Setting Properties of the Debug Tool

Before connecting the E1 emulator, open the Property panel by double-clicking on RX E1(JTAG) (debug tool) in the

Project Tree then set [Main clock frequency] and [Supply voltage] on the [Connect Settings] tabbed page.

In this project, the settings below have already made.

Select [No] for [Power target from the emulator] if an external power supply is to be provided to the target board.

Table

Properties Settings of the CubeSuite+ Project for RX610 [RX E1(JTAG)]

Tab

Category

Item

Setting

Connect Settings

Clock

Main clock frequency

[MHz]

12.5

Connection with

Target Board

Power target from the

emulator

(MAX 200 mA)

Yes

Supply voltage

3.3 V

7.

Building a Program

Selecting [Build] -> [Build Project] makes CubeSuite+ build the project. The results obtained by building the project

are displayed in the Output panel.

8.

Starting the E1 Emulator

Connect the E1 emulator to the Renesas Starter Kit.

Refer to the documentation accompanying the Renesas Starter Kit for the settings of switches on the board for the kit

and connection with the E1 emulator.

Select [Debug] -> [Download] from the menu.

The E1 emulator is started and downloads the program.

There are cases where the warning message shown below is output when the E1 emulator is started.