L160DB70VC datasheet(30/52 Pages) AMD

30 / 52 page

Am29LV160D

May 5, 2006 22358B7

DA TA

SH EET

DQ5: Exceeded Timing Limits

DQ5 indicates whether the program or erase time has

exceeded a specified internal pulse count limit. Under

these conditions DQ5 produces a “1.” This is a failure

condition that indicates the program or erase cycle

was not successfully completed.

The DQ5 failure condition may appear if the system

tries to program a “1” to a location that is previously

programmed to “0.” Only an erase operation can

change a “0” back to a “1.” Under this condition, the

device halts the operation, and when the operation

has exceeded the timing limits, DQ5 produces a “1.”

Under both these conditions, the system must issue

the reset command to return the device to reading

array data.

DQ3: Sector Erase Timer

After writing a sector erase command sequence, the

system may read DQ3 to determine whether or not an

erase operation has begun. (The sector erase timer

does not apply to the chip erase command.) If addi-

tional sectors are selected for erasure, the entire time-

out also applies after each additional sector erase com-

mand. When the time-out is complete, DQ3 switches

from “0” to “1.” The system may ignore DQ3 if the sys-

tem can guarantee that the time between additional

sector erase commands will always be less than 50

μs. See also the “Sector Erase Command Sequence”

section.

After the sector erase command sequence is written,

the system should read the status on DQ7 (Data# Poll-

ing) or DQ6 (Toggle Bit I) to ensure the device has

accepted the command sequence, and then read

DQ3. If DQ3 is “1”, the internally controlled erase cycle

has begun; all further commands (other than Erase

Suspend) are ignored until the erase operation is com-

plete. If DQ3 is “0”, the device will accept additional

sector erase commands. To ensure the command has

been accepted, the system software should check the

status of DQ3 prior to and following each subsequent

sector erase command. If DQ3 is high on the second

status check, the last command might not have been

accepted. Table 10 shows the outputs for DQ3.

Table 10.

Write Operation Status

Notes:

1. DQ5 switches to ‘1’ when an Embedded Program or Embedded Erase operation has exceeded the maximum timing limits.

See “DQ5: Exceeded Timing Limits” for more information.

2. DQ7 and DQ2 require a valid address when reading status information. Refer to the appropriate subsection for further

details.

Operation

DQ7

(Note 2)

DQ6

DQ5

(Note 1)

DQ3

DQ2

(Note 2)

RY/BY#

Standard

Mode

Embedded Program Algorithm

DQ7#

Toggle

N/A

No toggle

Embedded Erase Algorithm

Toggle

Erase

Suspend

Mode

Reading within Erase

Suspended Sector

No toggle

N/A

Toggle

Reading within Non-Erase

Suspended Sector

Data

Erase-Suspend-Program

DQ7#

Toggle

N/A

L160DB70VC Datasheet(PDF) 30 Page - Advanced Micro Devices

L160DB70VC Datasheet(HTML) 30 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Descarga

Enlace URL