HT360 datasheet(28/46 Pages) HANTEK

No. de pieza	HT360

Descripción Electrónicos	Leeb Hardness Tester

PDF	46 Pages

Scroll/Zoom	100%

Fabricante Electrónico	HANTEK [Qingdao Hantek Electronic Co., Ltd.]

Página de inicio	http://www.hantek.com/

Logo

28 / 46 page

Quick Start

HT360 series user manual

1 Open the support and you can see two screws. Remove the screws and remove

the battery cover to see the battery.

Figure 47 Opening the support

2 Please take out the battery from the negative pole, and take out the whole

battery after the negative pole leaves.

3 When installing the battery, make sure that the positive pole of the battery has an

insulating tube, otherwise, please refer to the following steps to install the

insulating heat shrink tube.

1) Prepare insulating heat shrink tube of the following sizes.

Size: thickness 0.2~0.3mm, inner diameter 18~19mm, length 21mm.

2) Put it on the positive pole of the battery.

3) Use a hot air gun with the temperature of 270 °to blow the tube for 5 seconds to

make the heat shrink tube stick to the battery.

HT360 Datasheet(PDF) 28 Page - Qingdao Hantek Electronic Co., Ltd.