AD9992BBCZ datasheet(29/92 Pages) AD

29 / 92 page

AD9992

Rev. C | Page 29 of 92

VERTICAL SEQUENCES (VSEQ)

The vertical sequences are created by selecting one of the V-pattern

groups and adding repeats, start position, horizontal clamping,

and blanking information. The V-sequences are programmed

using the registers shown in Table 14. Figure 35 shows how

the different registers are used to generate each V-sequence.

The VPATSELA, VPATSELB, VPATSELC, and VPATSELD

registers select which V-pattern is used in a given V-sequence.

Having four groups available allows different vertical outputs to

be mapped to different V-patterns. The selected V-pattern group

can have repetitions added for high speed line shifts or for line

binning by using the VREP registers for odd and even lines.

Generally, the same number of repetitions is programmed

into both registers. If a different number of repetitions is required

on odd and even lines, separate values can be used for each

and HBLK section). The VSTARTA and VSTARTB registers

specify where in the line the V-pattern group starts. The

VMASK_EN register is used with the FREEZE/RESUME

registers to enable optional masking of the V-outputs. Either or

both of the FREEZE1/RESUME1 and FREEZE2/RESUME2

registers can be enabled.

The line length (in pixels) is programmable using the HDLEN

registers. Each V-sequence can have a different line length to

accommodate various image readout techniques. The maximum

number of pixels per line is 8192. The last line of the field is

programmed separately using the HDLASTLEN register, which

is located in the field register section.

VREP 3

XV1 TO XV24

V-PATTERN GROUP

CLPOB

HBLK

VREP 2

PROGRAMMABLE SETTINGS FOR EACH VERTICAL SEQUENCE:

1START POSITION IN THE LINE OF SELECTED V-PATTERN GROUP.

2HD LINE LENGTH.

3V-PATTERN SELECT (VPATSEL) TO SELECT ANY V-PATTERN GROUP.

4NUMBER OF REPETITIONS OF THE V-PATTERN GROUP (IF NEEDED).

5START POLARITY AND TOGGLE POSITIONS FOR CLPOB AND PBLK SIGNALS.

6MASKING POLARITY AND TOGGLE POSITIONS FOR HBLK SIGNAL.

Figure 35. V-Sequence Programmability

AD9992BBCZ Datasheet(PDF) 29 Page - Analog Devices

AD9992BBCZ Datasheet(HTML) 29 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92

Datasheet Descarga

Enlace URL