7

Usage Precautions

 1. Plug

(1) Mating / un-mating

①To un-mate, use the extraction tool X.FL-LP-IN.OUT as shown in the following figure.

[How to un-mate a plug]

Do not un-mate a connector by pulling the cable as it may cause damage to the

connector.

②To mate a connector, use the mating side of the plug mating and unmating tool

X.FL-LPIN. OUT. Align the mating axes between both connectors and check that

the shell is properly aligned. The connector should be inserted perpendicularly as

much as possible. (See the following figure)

(2) Pull forces on the cable

after connectors are mated

Once the connector is mated, do not apply a load to the cable in excess of the values

indicated in the figure below.

Be careful when lifting the cable as it may add a load or cause unmating.

It is recommended to place buffer on the plug when wiring in a direction that causes the

cable to lift. (See figure below)

Buffer

（3）

Precautions

Do not mate or unmate a connector with an excessive force as it may damage the

connector.

X.FL(V)-LP-IN.OUT

2N Max.

C.FL-R-SMT-1

C.FL-LP(P)-044