AS5600-ASOM datasheet(23/44 Pages) OSRAM

23 / 44 page

Page 22

ams Datasheet

Document Feedback

[v1-06] 2018-Jun-20

AS5600 − Register Description

There are three recommended methods for programming the

angular range:

• Option A: Angle Programming Through the I²C Interface

• Option B: Angle Programming Through the OUT Pin

•Option C: Programming a Maximum Angular Range

Through the I²C Interface

Figure 24:

Option A: Angle Programming Through the I²C Interface

Note(s):

1. After each register command, the new setting is effective at the output at least 1 ms later.

2. It is highly recommended to perform a functional test after this procedure.

Use the correct hardware configuration shown in Figure 37 and Figure 38.

Step 1

Power up the AS5600.

Step 2

Turn the magnet to the start position.

Step 3

Read the RAW ANGLE register.

Write the RAW ANGLE value into the ZPOS register.

Wait at least 1 ms.

Step 4

Rotate the magnet in the direction defined by the level on the DIR pin (GND for clockwise, VDD

for counterclockwise) to the stop position. The amount of rotation must be greater than

18 degrees.

Step 5

Read the RAW ANGLE register.

Write the RAW ANGLE value into the MPOS register.

Wait at least 1 ms.

Proceed with Step 6 to permanently program the configuration.

Step 6

Perform a BURN_ANGLE command to permanently program the device.

Wait at least 1 ms.

Step 7

Verify the BURN_ANGLE command:

Write the commands 0x01, 0x11 and 0x10 sequentially into the register 0xFF to load the actual

OTP content.

Read the ZPOS and MPOS registers to verify that the BURN_ANGLE command was successful.

Step 8

Read and verify the ZPOS and MPOS registers again after a new power-up cycle.

AS5600-ASOM Datasheet(PDF) 23 Page - OSRAM GmbH

AS5600-ASOM Datasheet(HTML) 23 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Datasheet Descarga

Enlace URL