BAV20WS-TP datasheet(15/47 Pages) INFINEON

15 / 47 page

User Manual

15 of 47

Revision 1.4

2020-07-16

EVAL-M3-IM564 User Manual

iMOTION™ Modular Application Design Kit

Getting started with EVAL-M3-IM564

3.2

iMOTION™ development tools and software

The iMOTION™development tool installers for MCEDesigner and MCEWizard are available for download via

Infineon iMOTIONTMwebsite (http://www.infineon.com/imotion-software). All the available tools and software

variants are listed there.

The on-board debugger uses the SEGGER J-Link’s driver for UART communication with IMC102T-F064. The J-

Link driver will be installed during the MCEDesigner installation. In case the driver is not installed properly,

please go to SEGGER J-Link website to download and install the latest J-Link “Software and Documentation

pack for Windows.”

3.2.1

MCEWizard setup overview

After installing the MCEWizard, the shortcut for MCEWizard appears on the Windows desktop. Double-click the

shortcut to open the MCEWizard, and configure the parameters for evaluation boards and motor. Figure 5

shows the “Welcome Page” for MCEWizard, where the MADK control board or power board can be selected via

the pull-down list. Infineon continues to release new MADK controller and power boards. Therefore, it could

happen that some of the newest power boards are not pre-configured in the MCEWizard tool, and cannot be

selected via the pull-down menu. In that case, the user should select another power board (as similar as

possible) and follow the MCEWizard setup steps by entering the parameter values which are specific to the

chosen board. Make sure both “I have modified the circuit board” and “Enable advanced question” checkmarks

are selected (or check “Customized Design for Expert User”). Please refer to the user manual of the

corresponding power board for additional information.

After selecting the MADK control and power board, start the MCEWizard system setup procedure by clicking the

“Next” button in the right bottom corner as shown in Figure 5.

Figure 5

Welcome page of MCEWizard

iMOTION™ MADK system enables users to easily test different combinations of control and power boards with

their motors. Users should be familiar with the system level parameters which are related to the motor used.

BAV20WS-TP Datasheet(PDF) 15 Page - Infineon Technologies AG