BAV20WS-TP datasheet(13/47 Pages) INFINEON

13 / 47 page

User Manual

13 of 47

Revision 1.4

2020-07-16

EVAL-M3-IM564 User Manual

iMOTION™ Modular Application Design Kit

Getting started with EVAL-M3-IM564

In order to run the motor system, a combination of the iMOTION™ MADK power board (EVAL-M3-IM564) and the

matching MADK control board is required. The iMOTION™ software tools, MCEDesigner and MCEWizard, are also

required in order to initially set up the system, as well as to control and fine-tune the system performance to

match users’ exact needs. This chapter provides more details on setting up the system and getting started with

the iMOTION™ MADK development platform.

Note:

If you are using an EVAL-M3-102T control board, please make the following changes to better

match EVAL-M3-IM564 for OPA’s gain and PFC OCP level.

1. Delete R6 and R10 of EVAL-M3-102T

2. R13 of EVAL-M3-102T from 2 kohm change to 0 ohm

3. R25 of EVAL-M3-102T from 1 kohm change to 0 ohm

4. R8 of EVAL-M3-102T from 24 kohm change to 470 ohm

R9 of EVAL-M3-102T from 470 ohm change to 1.65 kohm for PFCTRIPREF

3.1

Setting up the system

After downloading and installing the iMOTION™ PC tools (MCEWizard and MCEDesigner), the following steps

need to be taken in order to run the motor. Refer to user manual for iMOTION™ MADK control board such as

(EVAL-M3-102T), MCEWizard and MCEDesigner documentation for more information.

Figure 4 shows the system connection using EVAL-M3-IM564 and control board (used control board EVAL-M3-

102T for example).

Figure 4

System connection example using EVAL-M3-IM564

PC-USB

Connector

AC Power

Input

Motor Phase

Outputs

PFC

Inductor

BAV20WS-TP Datasheet(PDF) 13 Page - Infineon Technologies AG