STM32G474PBY3XXX datasheet(128/236 Pages) STMICROELECTRONICS

128 / 236 page

Electrical characteristics

STM32G474xB STM32G474xC STM32G474xE

128/236

DS12288 Rev 5

Static latch-up

Two complementary static tests are required on three parts to assess the latch-up

performance:

•

A supply overvoltage is applied to each power supply pin.

•

A current injection is applied to each input, output and configurable I/O pin.

These tests are compliant with EIA/JESD 78E IC latch-up standard.

5.3.13

I/O current injection characteristics

As a general rule, current injection to the I/O pins, due to external voltage below VSS or

above VDD (for standard, 3.3 V-capable I/O pins) should be avoided during normal product

operation. However, in order to give an indication of the robustness of the microcontroller in

cases when abnormal injection accidentally happens, susceptibility tests are performed on a

sample basis during device characterization.

Functional susceptibility to I/O current injection

While a simple application is executed on the device, the device is stressed by injecting

current into the I/O pins programmed in floating input mode. While current is injected into

the I/O pin, one at a time, the device is checked for functional failures.

The failure is indicated by an out of range parameter: ADC error above a certain limit (higher

than 5 LSB TUE), out of conventional limits of induced leakage current on adjacent pins (out

of the -5 µA/+0 µA range) or other functional failure (for example reset occurrence or

oscillator frequency deviation).

The characterization results are given in Table 53.

Negative induced leakage current is caused by negative injection and positive induced

leakage current is caused by positive injection.

Table 52. Electrical sensitivities

Symbol

Parameter

Conditions

Class

Static latch-up class

TA = +125 °C conforming to JESD78E

Class II level A

Table 53. I/O current injection susceptibility

Symbol

Description

Functional

susceptibility

Unit

Negative

injection

Positive

injection

IINJ(1)

Injected current on pin

All except TT_a, PF10, PB8-BOOT0, PC10

-5

PF10, PB8-BOOT0, PC10

-0

TT_a pins

-5

1. Guaranteed by characterization.

STM32G474PBY3XXX Datasheet(PDF) 128 Page - STMicroelectronics

STM32G474PBY3XXX Datasheet(HTML) 128 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL