M7F datasheet(7/16 Pages) OMRON

7 / 16 page

M7F

■ Terminal Arrangement/Functions

Terminal Arrangement

Terminal Functions

DIP Switch Function

The DIP switch is used for symbol and decimal point settings. Refer to Terminal Arrangement, above, for details.

Signal inputPower supply

Signal input

Power supply

Case

mark

Signal input

Power supply

Polarity guide

Terminal name

Terminal guide

Signal input

Triangular

mark on

socket

Triangular

mark on

socket

Case

mark

XG4A Connector

Static Input Model

Dynamic Input Model

Note: 1. Circled numbers are for the user's convenience. When preparing a socket, pay attention

when wiring the terminals to the direction of the polarity guide.

2. The triangular mark (

) on the M7F case indicates the start of the M7F terminal numbers. It

does not line up with the triangular mark (

) on the connector. Incorrect wiring may cause a

short-circuit in the sequence output section, which could damage it.

* This is the location of the triangular mark on the XG4M-2030 Socket that is attached to the

Cable.

DIP Switch

Power supply (

−)

Power supply (

XG4A Connector

Input method

Terminal

symbol

Name

Function

Static input

First digit (100)

data input

A1 (20)

B1 (21)

C1 (22)

D1 (23)

The numeral or symbol corresponding to the binary code signal will be

displayed as the first digit (100).

Second digit (101)

data input

A2 (20)

B2 (21)

C2 (22)

D2 (23)

The numeral or symbol corresponding to the binary code signal will be

displayed as the second digit (101).

Third digit (102)

data input

A3 (20)

B3 (21)

C3 (22)

D3 (23)

The numeral or symbol corresponding to the binary code signal will be

displayed as the third digit (102).

Fourth digit (103)

data input

A4 (20)

B4 (21)

C4 (22)

D4 (23)

The numeral or symbol corresponding to the binary code signal will be

displayed as the fourth digit (103).

Power supply

Power supply and output terminal

0 V

Power supply

Power supply 0-V output terminal (GND)

Dynamic input

Data input

A (20)

B (21)

C (22)

D (23)

Displays the numeral or symbol corresponding to the binary code signal.

Control input

S0 (100)

S1 (101)

S2 (102)

S3 (103)

S4 (104)

Designates the digit to be displayed. Each digit will maintain the previous

value when this signal is input.

Power supply

Power supply and output terminal

0 V

Power supply

Power supply 0-V output terminal (GND)

M7F Datasheet(PDF) 7 Page - Omron Electronics LLC

M7F Datasheet(HTML) 7 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Descarga

Enlace URL