Features
■ Non-Sensitizing per ISO:10993
■ Easy to Handle/Apply
■ Cushioning¹ & Insulating
■ ETO and Gamma Sterilization Compatible
■ Opaque Light Tan
■ Printable²1 Composition: Tape is ~34 mils [0.9 mm] thick without release liner target thickness. Backing 32 mil (0.8 mm) Tan Polyolefin Closed-Cell Foam2 Adhesive Non-tackified Acrylic-based, developed for skin contact Liner 76 lbs. Bleached DC Poly-coated Kraft paper, silicone release on one side, 5.7 mils ± 0.5 mils (0.14 mm ± 0.01 mm) Please note - The following technical information should be considered representative or typical only and should not be used for specification purposes. Typical Properties: *3M test methods are available upon request. Adhesion to Stainless Steel*, 180 deg 32 ounces/inch width (900 g/25mm width) (8.8 N/25 mm) Liner Release*, average 30 grams/inch width (30 gm/25 mm width) Roll Description: Tape supplied on 3 inch (76 mm) diameter cores. Length, Maximum 145 yards (133 meters) + 2 % Width, Maximum 48 inches (122 cm) + 1/16 inch (1.5 mm) Splices: Splices on the tape are intended for continuous processing. 3 inch [76mm Roll Width Maximum Number of Splices per Roll < 8 inches (20 cm) 4 per 145 yards (133 meters) Recommended Storage and Rollstock Shelf Life: Product as supplied in original packaging will maintain stated properties for a period of two (2) years from date stamped on shipping container when stored at temperatures of 50-80ºF (10-27ºC) and a relative humidity between 40-60 percent. Please see reverse side for important product, safety and warranty information. 1Conditions based on 3M internal studies may not be representative of actual end use/performance and we recommend our OEM customers run their own studies using their device design. 2 May require pre-treatment or primer to increase ink anchorage before printing.