SPSEMI

..

.

www.spsemi.cn

Page 2 of 2

Electrical Characteristics

Spark-over

Voltage

(@100V/s

）

(V)

Part Number

Spark-over

Voltage

(@1KV/μs)

(V)

Nom.Impulse

Discharge

Current

(@8/20μs)

(KA)

(A)

Capacitance

(pF)

Insulation

Resistance

(GΩ)

(@DC)

(V)

SPD090FD

90

20

±%

≦700

10

31

>1

50

<1

Surge Characteristics

Test Item

Surge withstand capability

Surge life test

In the glass tube ends in 8/20 us surge tester, applying the model that

corresponds to the impact resistance current, time interval for the

60 s of plus or minus the test 5 times. Test the dc voltage,

insulation resistance, static capacitance and check the appearance.

Apply 10KV voltage charged in 1500pF condenser and

apply the current to the specimen,200 times at 10

seconds of intervals.

Test Method

Specification

DC spark-over voltage

JSE:

Vs/Vs

30%

△≦

Within standard mentioned in

Initial Characteristics.

Impulse

Discharge

Current

(@10/1000μs)

300times

Cold resistance

After -40±3

℃

(1000hrs) / room temp.,normal humidity(4 hrs)

cycle, measure the properties.

Within standard mentioned in

Initial Characteristics.

Within standard mentioned in

Initial Characteristics.

Within standard mentioned in

Initial Characteristics.

Within standard mentioned in

Initial Characteristics.

After 125±2

℃

(1000hrs) / room temp.,normal humidity(4 hrs)

cycle, measure the properties.

After 85±2

℃

RH85%(1000hrs) / room temp.,normal humidity(4

hrs) cycle, measure the properties.

25 times repetition of cycle -40±3

℃

(30 Min.),roon temp., (4 Min.), 125±2

(30Min.),

℃

room temp., normal humidity(4hrs) .

Heat resistance

Temperature resistance

Temperature period

Tensile strength

Bending strength

Resistance to soldering

attachment

（）

by solder dip

Resistance to soldering

heat

（）

by solder dip

Apply 2.5kgs load approximately 30 seconds, then check

for pull-out and breaking of the lead wire.

Within standard mentioned in

Initial Characteristics.

Within standard mentioned in

Initial Characteristics.

Bend the lead wire, with jig which radius is 0.75~0.8mm, at the point

of 2mm from the body, under 0.25 kgs load applied at the right angle

the direction of theamis and get the bent lead wire back to its

original poing after the procedure was repeated 2times.

Apply flux and immerse in molten solder, up to the point of

3mm from the body,for 5 sec. (235

±5

). Wash

℃℃

the leadwire and check for soldering adhesion.

Lead wire is evenly covered by

solder over 90%.

Apply flux and immerse in molten solder, up to the point of 3mm

from the body,for 5 sec. (235

±5

). Wash the leadwire

℃℃

and check forsoldering adhesion.)

Within standard mentioned in

Initial Characteristics.

GDT/SPD090FD

REV 2017 09 04