A42180-R datasheet(28/32 Pages) SEOUL

No. de pieza	A42180-R

Descripción Electrónicos	Full Code of Z-Power LED Series

PDF	32 Pages

Scroll/Zoom	100%

Fabricante Electrónico	SEOUL [Seoul Semiconductor]

Página de inicio	http://www.seoulsemicon.com

Logo

28 / 32 page

Rev. 10

February. 2011

www.acriche.com

Document No. : SSC-QP-7-07-24 (Rev.00)

3. Reflow Soldering Conditions / Profile

4. Hand Soldering conditions

Lead : Not more than 3 seconds @MAX280℃

Slug : Use a thermal-adhesives

Pre-heating

200

180

150

220

240

260

Rising

5 °C/sec

Tm : Reflow machine setting temp (max 30 sec.)

Ts : Surface temp of PCB (min)

Ts : Surface temp of PCB (max)

Ts : Surface temp of PCB (recommend)

Cooling

-5 °C/sec

Time

[Hr]

* Caution

1. Reflow soldering should not be done more than one time.

2. Repairing should not be done after the LEDs have been soldered.

When repairing is unavoidable, suitable tools have to be used.

3. Die slug is to be soldered.

4. When soldering, do not put stress on the LEDs during heating.

5. After soldering, do not warp the circuit board.

6. Recommend to use a convection type reflow machine with 7 ~ 8 zones.

A42180-R Datasheet(PDF) 28 Page - Seoul Semiconductor