XT40.721, XT40.722

– X-Series

Jan. 2007 / Rev. 1.0 DS-XT40.72x-EN All parameters are specified at 72V 13.3A, 3x400Vac (XT40.721) or 3x480Vac (XT40.722),

25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

9/19

Use appropriate copper cables that are designed for a minimum operating temperatures of 60°C (for ambient up to

45°C) and 75°C (for ambient up to 60°C). Follow national installation codes and regulations! Ensure that all strands of

a stranded wire enter the terminal connection! Do not use the power supply without PE (Ground) connection! Up to

two stranded wires with the same cross section are permitted in one connection point (except PE wire). Ferrules are

allowed, but not required.

Input

Output

Type

Screw terminal

Screw terminal

Solid wire

0.5-6mm

2

0.5-16mm

2

Stranded wire

0.5-4mm

2

0.5-10mm

2

American wire gauge

20-10 AWG

22-8 AWG

Wire stripping length

7mm / 0.26inch

12mm / 0.5inch

Recommended tightening torque

0.8Nm / 7lb.inch

1.2Nm / 10.6lb.inch

Lifetime expectancy

min.

t.b.d.

40°C, 13.3A

min.

t.b.d.

40°C, 6.7A

min.

t.b.d.

25°C, 13.3A

MTBF SN 29500, IEC 61709

539 000h

40°C, 13.3A

979 000h

25°C, 13.3A

MTBF MIL HDBK 217F

216 000h

40°C, 13.3A, Ground Benign GB40

296 000h

25°C, 13.3A, Ground Benign GB25

The Lifetime expectancy shown in the table above indicates the operating hours (service life) and is determined by

the lifetime expectancy of the built-in electrolytic capacitors.

Lifetime expectancy is specified in operational hours and is calculated according to the capacitor’s manufacturer

specification. The prediction model allows a calculation of up to 15 years from date of shipment.

MTBF stands for Mean Time Between Failure, which is calculated according to statistical device failures, and indicates

reliability of a device. It is the statistical representation of the likelihood of a unit to fail and does not necessarily

represent the life of a product.