USB2517I datasheet(16/58 Pages) MICROCHIP

16 / 58 page

USB2517/USB2517I

DS00001598B-page 16

 2013-2016 Microchip Technology Inc.

5.2

Buffer Type Descriptions

2-Wire

I2C EEPROMS are supported

• Strap Options are Disabled

• All Settings are Controlled by Registers

Internal Default Configuration

• Strap Options are Disabled

• Dynamic Power Switching is Enabled

Internal Default Configuration

• Strap Options are Disabled

• Dynamic Power Switching is Enabled

• LED Mode = USB

Internal Default Configuration

• Strap Options are Disabled

Internal Default Configuration

• Strap Options are Disabled

• LED Mode = USB

• Ganged Power Switching

• Ganged Over-Current Sensing

TABLE 5-3:

USB2517/USB2517I BUFFER TYPE DESCRIPTIONS

Buffer

Description

Input.

IPD

Input with internal weak pull-down resistor.

IPU

Input with internal weak pull-up resistor.

Input with Schmitt trigger.

O12

Output 12mA.

I/O12

Input/Output buffer with 12mA sink and 12mA source.

I/OSD12

Open drain...12mA sink with Schmitt trigger, and must meet

I2C-Bus Specification

Version 2.1 requirements.

ICLKx

XTAL clock input.

OCLKx

XTAL clock output.

I-R

RBIAS.

IO-U

Analog Input/Output Defined in USB specification.

TABLE 5-2:

USB2517I SMBUS OR EEPROM INTERFACE BEHAVIOR (CONTINUED)

CFG_SEL2

CFG_SEL1

CFG_SEL0

SMBus or EEPROM Interface Behavior

USB2517I Datasheet(PDF) 16 Page - Microchip Technology

USB2517I Datasheet(HTML) 16 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Datasheet Descarga

Enlace URL