MTCH6301T-ISLASHML datasheet(13/40 Pages) MICROCHIP

13 / 40 page

 2012-2014 Microchip Technology Inc.

DS40001663B-page 13

MTCH6301

6.3

Generic Read/Write Protocol

6.3.1

MASTER READ WAVEFORM

FIGURE 6-1:

MASTER READ WAVEFORM

6.3.2

MASTER WRITE WAVEFORM

FIGURE 6-2:

MASTER WRITE WAVEFORM

Note 1: The first byte read from the device denotes the number of bytes to follow.

2: The last byte read from the device must be followed by a nACK (‘1’) from the host controller. All other bytes

should be followed with ACK (‘0’).

3: INT will be set low within 10 uS of a correct I2C™ address match.

4: All data (DATA0 – DATAn) must be read at once within a single I2C™ transaction, and Restart conditions

are not supported.

ACK

NACK

ACK

Stop

D7 D6 D5 D4 D3 D2 D1 D0

0x25

[NUM_BYTES]

[DATA0]

[DATAn]

Start

INT

SCL

SDA

(DATA)

Note 1: If the device is sleeping, it will ACK the address byte, but will not ACK the first byte of the transmission

until it is awake. See Section 9. “Send Enable Touch command (0x00).” for details.

2: The first byte written to the controller denotes the number of bytes to follow.

3: Although it is not required all data be written in a single I2C™ transaction, it is recommended to reduce

the chance of a timeout occurring.

ACK

Stop

D7 D6 D5 D4 D3 D2 D1 D0

0x25

[NUM_BYTES]

[DATA0]

[DATAn]

Start

INT

SCL

SDA

(DATA)

ACK

MTCH6301T-I/ML Datasheet(PDF) 13 Page - Microchip Technology

MTCH6301T-I/ML Datasheet(HTML) 13 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Descarga

Enlace URL