System Board 6261

MAXREFDES112#: ISOLATED 24V TO 12V 10W

FLYBACK POWER SUPPLY

Design Resources

Quick Start

Required equipment:

• MAXREFDES112# board

• One 24V DC power supply

• One electronic load

•1 voltmeters

• 1 ammeters

Procedure

The MAXREFDES112# board is fully assembled and tested. Use the following steps to

verify board operation.

1. Turn off the power supply.

2. Connect the positive terminal of the power supply to the VIN pin of the

MAXREFDES112# board.

3. Connect the negative terminal of the power supply to the GND pin of the

MAXREFDES112# board.

4. Connect the VOUT connector of the MAXREFDES112# board to the positive

terminal of the electronic load.

5. Connect the negative terminal of the electronic load to the positive terminal of the

ammeter.

6. Connect the negative terminal of the ammeter to the GNDO connector of the

MAXREFDES112# board.