T89C51CC02CA-RATIM datasheet(102/154 Pages) ATMEL

102 / 154 page

102

T89C51CC02

4126H–CAN–01/05

Table 69. CANSTCH Register

CANSTCH (S:B2h) – CAN Message Object Status Register

Note:

See Figure 39.

No default value after reset.

765

43210

DLCW

TXOK

RXOK

BERR

SERR

CERR

FERR

AERR

Bit Number

Bit Mnemonic

Description

7DLCW

Data Length Code Warning

The incoming message does not have the DLC expected.

Whatever the frame type, the DLC field of the CANCONCH register

is updated by the received DLC.

6TXOK

Transmit OK

The communication enabled by transmission is completed.

When the controller is ready to send a frame, if two or more

message objects are enabled as producers, the lower index

message object (0 to 13) is supplied first. Must be cleared by

software.

This flag can generate an interrupt.

5RXOK

Receive OK

The communication enabled by reception is completed.

In the case of two or more message object reception hits, the lower

index message object (0 to 13) is updated first. Must be cleared by

software.

This flag can generate an interrupt.

4BERR

bit Error (only in transmission)

The bit value monitored is different from the bit value sent.

Exceptions:

the monitored recessive bit sent as a dominant bit during the

arbitration field and the acknowledge slot detecting a dominant bit

during the sending of an error frame. Must be cleared by software.

This flag can generate an interrupt.

3SERR

Stuff Error

Detection of more than five consecutive bits with the same polarity.

Must be cleared by software.

This flag can generate an interrupt.

2CERR

CRC Error

The receiver performs a CRC check on each destuffed received

message from the start of frame up to the data field.

If this checking does not match with the destuffed CRC field, a CRC

error is set. Must be cleared by software.

This flag can generate an interrupt.

1FERR

Form Error

The form error results from one or more violations of the fixed form

in the following bit fields:

CRC delimiter

acknowledgment delimiter

end_of_frame

Must be cleared by software.

This flag can generate an interrupt.

0AERR

Acknowledgment Error

No detection of the dominant bit in the acknowledge slot. Must be

cleared by software.

This flag can generate an interrupt.

T89C51CC02CA-RATIM Datasheet(PDF) 102 Page - ATMEL Corporation

T89C51CC02CA-RATIM Datasheet(HTML) 102 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL