TAS3208IPZP datasheet(23/79 Pages) TI1

23 / 79 page

TAS3208

www.ti.com

SLES201E

– JANUARY 2007 – REVISED MARCH 2011

Embedded M8051 WARP Microcontroller

The embedded M8051 WARP microcontroller provides the overall control for the TAS3208 device. This control

includes device initialization, memory loading, I2C transactions, control-pin operations, and participation in most

processing tasks requiring multiframe processing cycles.

The microcontroller has its own data RAM for storing intermediate values and queuing I2C commands, a fixed

boot program ROM, and a programmable program RAM. The microprocessor

’s boot program cannot be altered.

The microcontroller has specialized hardware for a master and slave interface operation, volume updates, and a

programmable interval timer interrupt.

M8051 Addressing Modes

The 256 bytes of internal data memory address space are accessible using indirect addressing instructions

(including stack operations). However, only the lower 128 bytes are accessible using direct addressing. The

upper 128 bytes of direct address data memory space are used to access external special function data registers

(ESFRs).

There are four directly addressable register banks, only one of which may be selected at one time. The register

banks occupy Internal data memory addresses from 00 hex to 1F hex.

Bit Addressing

The 16 bytes of internal data memory that occupy addresses from 20 hex to 2F hex are bit addressable. ESFRs

that have addresses in the form 1XXXX000 binary are also bit addressable.

Scratch Pad

Internal data memory occupying direct addresses from 30 hex to 7F hex can be used as scratch-pad registers or

for the stack.

External Data Memory

External data RAM occupies a 64K address space. This space contains ESFRs. ESFRs permit access and

control of the hardware features and internal interfaces of the TAS3208 DSP.

M8051 Boot-Up Sequence

Figure 17 shows the boot-up sequence. M8051 MCU ROM code follows this sequence after device reset

release. After the micro completes the boot-up application code (RAM code), the microcontroller switches the

program counter from ROM to RAM code by pc_source(esfr - 0xFD).

Submit Documentation Feedback

Product Folder Link(s): TAS3208

TAS3208IPZP Datasheet(PDF) 23 Page - Texas Instruments