LMH6732MFXSLASHNOPB datasheet(21/29 Pages) TI1

21 / 29 page

LMH6732

www.ti.com

SNOSA47B – FEBRUARY 2003 – REVISED MARCH 2013

For ICC > 9mA at any closed loop gain setting, a good starting point for RF would be the 9mA value stated in

Table 2 above. This value could then be readjusted, if necessary, to achieve the desired response.

PRINTED CIRCUIT LAYOUT & EVALUATION BOARDS

Generally, a good high frequency layout will keep power supply and ground traces away from the inverting input

and output pins. Parasitic capacitances on these nodes to ground will cause frequency response peaking and

possible circuit oscillations (see Application Note OA-15 (SNOA367) for more information).

Use the following evaluation boards as a guide for high frequency layout and as an aid in device testing and

characterization:

Evaluation Board

Device

Package

Part Number

LMH6732MF

SOT-23

LMH730216

LMH6732MA

SOIC

LMH730227

The supply current adjustment resistor, RP, in both evaluation boards should be tied to the appropriate potential

to get the desired supply current. To do so, leave R2 (LMH730216) [ R5 (LMH730227) ] uninstalled. Jumper

"Dis" connector to V

−. Install R1 (LMH730216) [ R4 (LMH730227) ] to set the supply current.

Submit Documentation Feedback

Product Folder Links: LMH6732

LMH6732MFX/NOPB Datasheet(PDF) 21 Page - Texas Instruments