LF205-P datasheet(2/2 Pages) LEM

2 / 2 page

Secondary terminals

Terminal +

: supply voltage + 12 .. 15 V

Terminal M : measure

Terminal -

: supply voltage - 12 .. 15 V

Remarks

• I

S is positive when IP flows in the direction of the arrow.

• Temperature of the primary conductor should not exceed

100°C.

• Dynamic performances (di/dt and response time) are best

with a single bar completely filling the primary hole.

• This is a standard model. For different versions (supply

voltages, turns ratios, unidirectional measurements...),

please contact us.

Mechanical characteristics

• General tolerance

± 0.2 mm

• Fastening & secondary connection 3 pins 0.63x0.56 mm

Recommanded PCB hole

∅ 0.9 mm

• Primary through-hole

∅ 15.5 mm

• Supplementary fastening

2 holes

∅ 1.75 mm

Recommended PCB hole

2.4 mm

Recommended screws

KA22 x 6

LEM code

47.30.60.006.0

Dimensions LF 205-P (in mm. 1 mm = 0.0394 inch)

Bottom view

Top view

LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.

Connection

Front view

Back view

Left view

LF205-P Datasheet(PDF) 2 Page - LEM