B135

BPrecautions

1. Recommended Soldering Condition

Flow: 250ç for 3 seconds

Manual soldering: 290ç for 2 seconds

sAfter the soldering process, if a load is applied to the cable in the state where the connector

and the cable contains heat, the cable jacket holding members are apt to be loosened.

Therefore, the post-soldering process should be carried out after the connector temperature

returns to the room temperature.

2. Cleaning Condition

Refer to Nylon Connector Use Hand book.

Don't use such a solvent as trichloroethane which degrades the cable jacket.

In addition, avoid heat cleaning with such a solvent.

3. Connection Condition

Refer to Nylon Connector Use Hand book.