GP2010 datasheet(7/24 Pages) MITEL

7 / 24 page

GP2010

Pin No.

Signal Name

Input/Output

Description

PDn

Input

Power-Down control input.

A TTL compatible input, which when set to logic high, will

disable ALL of the GP2010 functions, except the power-on

reset block. Useful to reduce the total power consumption of

the GP2010. If this feature is not required, the pin should be

connected to 0V (VEE/GND).

TEST

Input

Test control input - Disable PLL.

A TTL compatible input, which when set to logic high, will

disable the on-chip PLL, by disconnecting the divided-down

VCO signal to the phase-detector. The VCO will free run at its

upper range of frequency operation. If this feature is not

required, the pin should be connected to 0V (VEE/GND).

Output

PLL Lock Detect output.

A TTL compatible output, which indicates if the PLL is phase-

locked to the PLL reference oscillator. Will become logic high

only when phase-lock is achieved.

VEE (DIG)

Input

Negative supply to the PLL and A to D converter.

AGC-

Output

AGC Capacitor output - inverse phase.

One side of a balanced output from the AGC block within IF

Stage 3, to which an external capacitor is connected to set the

AGC time-constant.

AGC+

Output

AGC Capacitor output - true phase.

One side of a balanced output from the AGC block within IF

Stage 3, to which an external capacitor is connected to set the

AGC time-constant.

VCC (DIG)

Input

Positive supply to the PLL and A to D converter.

REF 2

Input

10.000MHz PLL Reference signal input .

Input to which an externally generated 10.000MHz PLL

reference signal should be ac coupled, if an external PLL

reference frequency source (e.g TCXO) is used (see fig. 6).

If no external reference is used, this pin forms part of the on-

chip PLL reference oscillator, in conjunction with an external

10.000MHz crystal (see fig. 5).

REF 1

Input

PLL reference oscillator auxillary connection.

Used in conjunction with Pin 24 (REF 2) to allow a 10.000MHz

external crystal to provide the PLL reference signal if no

external PLL reference frequency source (e.g TCXO) is used.

This pin should NOT be connected if an external TCXO is

being used (see fig. 5).

26, 32

VCC (RF)

Input

Positive supply to the RF input and Stage 1 IF mixer.

Both pins 26 & 32 (VCC (RF)) are connected internally, but

must both be connected to VCC externally, to keep series

inductance to a minimum.

27, 28,

VEE (RF)

Input

Negative supply to the RF input and Stage 1 IF mixer.

30, 31

Pins 27, 28, 30 & 31 are all connected internally, but must ALL

be connected to 0V (VEE/GND) externally, to keep series

inductance to a minimum.

GP2010 Datasheet(PDF) 7 Page - Mitel Networks Corporation

GP2010 Datasheet(HTML) 7 Page - Mitel Networks Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Datasheet Descarga

Enlace URL