Quad Digital Control Amplifier

8

MX019

1998 MX-COM, INC.

www.mxcom.com Tel: 800 638 5577 910 744 5050 Fax: 910 744 5054

Doc. # 20480077.006

4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA

All trademarks and service marks are held by their respective companies

5. Application

To avoid excess noise and instability you should take note of the following:

1. A noisy or badly regulated power supply can cause instability and/or variance of selected gains.

2. Care should be taken on the design and layout of the printed circuit board.

3. All external components (Figure 2) should be kept close to the MX019 package.

4. Inputs and outputs should be shielded wherever possible.

5. Tracks should be kept short.

6. Analog tracks should not run parallel to digital tracks.

output pins.

8. Do not run high-level output tracks close to low-level input tracks.

6. Performance Specification

6.1 Electrical Performance

6.1.1 Absolute Maximum Ratings

Exceeding these maximum ratings can result in damage to the device.

General

Min.

Max.

Units

Supply Voltage

-0.3

7.0

V

-0.3

V

Current

±30

mA

±30

mA

Any other pins

±20

mA

J/P/DW Packages

800

mW

Derating above 25°C

10

mW/°C above 25°C

TN Packages

500

mW

Derating above 25°C

9

mW/°C above 25°C

Operating Temperature

-40

85

°C

Storage Temperature

-55

125

°C

6.1.2 Operating Limits

Correct operation of the device outside these limits is not implied.

Min.

Typ.

Max.

Units

4.5

5.0

5.5

V

Operating Temperature

-40

85

°C