LM78XXL-T2Q-R datasheet(11/13 Pages) UTC

No. de pieza	LM78XXL-T2Q-R

Descripción Electrónicos	3-TERMINAL 1A POSITIVE VOLTAGE REGULATOR

PDF	13 Pages

Scroll/Zoom	100%

Fabricante Electrónico	UTC [Unisonic Technologies]

Página de inicio	http://www.utc-ic.com

Logo

11 / 13 page

LM78XX

LINEAR INTEGRATED CIRCUIT

UNISONICTECHNOLOGIESCO.,LTD

11 of 13

www.unisonic.com.tw

QW-R101-006.U



NOTES FOR USE(Cont.)

9. Ground Wiring Pattern

When using both small signal and large current GND patterns, it is recommended to isolate the two ground

patterns, placing a single ground point at the ground potential of application so that the pattern wiring resistance

and voltage variations caused by large currents do not cause variations in the small signal ground voltage. Be

careful not to change the GND wiring pattern of any external components, either.

10. Damage to the internal circuit or element may occur when the polarity of the VCC pin is opposite to that of

the other pins in applications.

(I.e. VCC is shorted with the GND pin while an external capacitor is charged.)

Use a maximum capacitance of 1000μF for the output pins. Inserting a diode to prevent back-current flow in

series with VCC or bypass diodes between VCC and each pin is recommended.

LM78XXL-T2Q-R Datasheet(PDF) 11 Page - Unisonic Technologies