UM0463 datasheet(22/30 Pages) STMICROELECTRONICS

22 / 30 page

Data transfer on noncontrol endpoints

UM0463

22/30

For ST7SCR, there are six operations available to set status registers:

●

USB_SetTxEP1Status(Status) // Set the endpoint 1 sending status

●

USB_SetTxEP2Status(Status) // Set the endpoint 2 sending status

●

USB_SetRxEP2Status(Status) // Set the endpoint 2 receiving status

●

USB_SetTxEP3Status(Status) // Set the endpoint 3 sending status

●

USB_SetTxEP4Status(Status) // Set the endpoint 4 sending status

●

USB_SetTxEP5Status(Status) // Set the endpoint 5 sending status

In the above operations, Status is the state that will be set.

4.3.2

DMA counter registers

The sending DMA counter register for each endpoint is defined as CNTxTXR and the

receiving DMA counter register for each endpoint is defined as CNTxRXR, where x

represents the endpoint number.

4.3.3

DMA buffers

The DMA buffer for each sending endpoint is defined as EPx_IN and the DMA buffer for

each receiving endpoint is defined as EPx_OUT, where x represents the endpoint number.

4.3.4

Sending data to the host

Follow the steps below to send data to the host:

Check if the endpoint status is EP_NAK to ensure that the previous data in the buffer is

sent.

Copy the data to be sent to the DMA buffer of the endpoint.

Set the length of data to be sent to the corresponding endpoint DMA counter register.

Set the sending endpoint status to EP_VALID.

Check that the endpoint status becomes EP_NAK again to ensure that the data is sent.

4.3.5

Receiving data from the host

Follow the steps below to receive data from the host

Check if the endpoint status is EP_NAK to ensure that the EP is free to receive data.

Ensure that the data in the endpoint DMA buffer is useless to avoid the loss of useful

data.

Set the length of data expected to the corresponding endpoint DMA counter register.

Set the receiving endpoint status to EP_VALID.

Check that the endpoint status becomes EP_NAK from EP_VALID.

Subtract the current value of the endpoint DMA counter register from the value set in

step 2 to get the actual length of the received data.

Process the received data.

UM0463 Datasheet(PDF) 22 Page - STMicroelectronics

UM0463 Datasheet(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Datasheet Descarga

Enlace URL