AN2350 datasheet(22/41 Pages) STMICROELECTRONICS

No. de pieza	AN2350

Descripción Electrónicos	Guidelines for the control of a multiaxial planar robot with ST10F276

PDF	41 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

22 / 41 page

Hardware and mechanical equipments

AN2350

22/41

Figure 15.

The conditioning circuit for one absolute encoder

The sector C represents the incremental 12-bit encoder, whose outputs are two sinusoidal

signals (available in orange and green wires) shifted to each other by 90 degrees, with an

offset of 2.5 V and a peak-to-peak voltage of 1.1 V.

Since these signals can not be directly managed by the microcontroller, it has been

necessary to develop a conditioning circuit whose outputs are digital signals.

This conditioning circuit for each sinusoidal signal consists of a comparator whose output is

at a logical high level (5 V) every time the input signal level is over 2.5 V, and at logical low

level (0 V) every time the level of the input signal is below 2.5 V. A detail of the conditioning

circuit for one of the incremental encoders of the wafer handler is shown in the following

figure.

AN2350 Datasheet(PDF) 22 Page - STMicroelectronics