LTC4076 datasheet(14/16 Pages) LINER

14 / 16 page

LTC4076

4076fa

Figure 4. Low Loss Input Reverse Polarity Protection

Protecting the USB Pin and Wall Adapter Input from

Overvoltage Transients

Caution must be exercised when using ceramic capacitors

to bypass the USBIN pin or the wall adapter inputs. High

voltage transients can be generated when the USB or wall

adapter is hot plugged. When power is supplied via the

USB bus or wall adapter, the cable inductance along with

the self resonant and high Q characteristics of ceramic

capacitors can cause substantial ringing which could

exceed the maximum voltage ratings and damage the

LTC4076. Refer to Linear Technology Application Note 88,

entitled “Ceramic Input Capacitors Can Cause Overvoltage

Transients” for a detailed discussion of this problem.

APPLICATIO S I FOR ATIO

Always use an oscilloscope to check the voltage wave-

forms at the USBIN and DCIN pins during USB and wall

adapter hot-plug events to ensure that overvoltage

transients have been adequately removed.

Reverse Polarity Input Voltage Protection

In some applications, protection from reverse polarity

voltage on the input supply pins is desired. If the sup-

ply voltage is high enough, a series blocking diode can

be used. In other cases where the voltage drop must be

kept low, a P-channel MOSFET can be used (as shown in

Figure 4).

WALL

ADAPTER

DCIN

LTC4076

DRAIN-BULK

DIODE OF FET

4076 F04

LTC4076 Datasheet(PDF) 14 Page - Linear Technology